Scraperite double-edged plastic razor blades are great for scraping and cleaning wherever a metal blade would be inappropriate.

How Do I Use My Scraperite??

​​Plastic razor blades are such a handy little tool, but where can I use them? Well, there is no one correct answer - there are so many different ways a plastic razor blade can be used, on a plethora of different surfaces. There are even different types of blades depending on what surface you're working on - wood, metal, glass - the possibilities are endless!

Continue reading
146 Hits
0 Comments

Crucial Tips for Maintaining your Boat

Boats, more than any other form of transportation, suffer hugely from wear and tear. This is because of their exposure to extreme weather even when they are moored at a pier. Care and maintenance are important in prolonging your boat's service life.

Here are some basic-but-important tips to help you keep your boat in good working condition:



Continue reading
280 Hits
0 Comments

Removing Pesky Gum from your Carpets?

If your cleaning company is responsible for carpet spotting or overall carpet cleaning, you are eventually going to run across gum that is smashed into the carpet fibers. You may be cleaning up just a piece or two or if you are cleaning the carpet in a school or bowling alley, you may be removing gum every few feet. So is there a fast, easy way to remove these rubbery pieces of goo?



Continue reading
330 Hits
0 Comments

Car Care - Use Deionised Water For the Final Rinse

One of the worst things to contend with when you are washing your car, especially on hot Summer days is water spots. No matter how hard you try it is sometimes almost impossible to stop water spots from appearing as your car dries. If this is a problem you are suffering from every time you wash your car then you will be pleased to know that the cause has been identified. You are using the wrong sort of water!



Continue reading
317 Hits
0 Comments

Will 3D Printing Be the Demise of Plastic Injection Molding?

Some observers of the plastics manufacturing industry, especially those with a vested interest, would like to have you believe that 3D printing is going to be the demise of injection molding. While there are certainly cases where 3D printing makes sense, the reports of the death of injection molding have been greatly exaggerated.




Continue reading
295 Hits
0 Comments